How to change the floor drain without damaging the

2022-07-22
  • Detail

The floor drain at home is old or broken and needs to be replaced. Friends who want to be simpler should pay attention to avoiding the damage of the waterproof layer when replacing the floor drain. Then, how can the floor drain not damage the waterproof layer? Let's take a look at the replacement steps with Xiaobian

the floor drain at home is old or broken and needs to be replaced. Friends who want to be simpler should pay attention to avoiding damage to the waterproof layer when replacing the floor drain. Then, how can the floor drain not damage the waterproof layer? Let's take a look at the replacement steps with Xiaobian

how to replace the floor drain without damaging the waterproof layer

replace it according to the following steps:

1. Before replacing the floor drain, you need to pay attention to the basic information such as the panel and size specification of the old floor drain currently used. The most used floor drains in the bathroom at home are 10*10cm square floor drains, and there are also 12cm circular floor drains; As for the size of the sewer pipe in the toilet, the diameter of the sewer pipe in general residential houses is 50mm. Note that the size of the new panel to be replaced should be consistent with the size of the old floor drain

2. Use a screwdriver or other tools to slowly lift and separate the joint between the old floor drain panel and the ceramic tile, use a slotted screwdriver to lift the cement around the floor drain, and then knock the floor drain with a small hammer to separate it from the cement; Clean up the cement layer around the old drain pit with a slot, and pay attention to the temporary plugging of the drain pipe to prevent debris from falling into the drain pipe

3. After cleaning, scrape cement putty around the pit wall. Cement putty is also applied around the reverse side of the new floor drain that needs to be replaced, so that it can be firmly combined with the ground, and the excess cement dining area is cleared of ground garbage. Before installing a new floor drain, it is necessary to take out the odor proof core to prevent cement sand and other creatures from entering the core and affecting the use effect; The newly replaced floor drain panel should be aligned with the ceramic tile, and the height should not be higher than the ceramic tile. Apply glass glue or white cement around it and dry it; After installation, install the odor proof core of the floor drain and put on the grate; It is suggested that the deodorization core can be taken out and cleaned once a month or so, and the use effect is better

the above brief introduction about how to change the floor drain without damaging the waterproof layer is here. I hope it will be helpful to you. Please look forward to more information

长春性病医院

广州癫痫医院

天津皮肤病医院

Copyright © 2011 JIN SHI